On Line Shopping Mall
Selected Products
 
                                                                           
   WELLNESS FROM FINLAND
          The Biggest Name In Saunas. Since 1968
 
 

Finninfra

Infrared cabin - easy to place, easy to use

The Finninfra cabin, available in one size – for three persons – is made of patented wood board in combination with metal. The straight parts of the cabin walls and the ceiling are wood board, the curved corners are metal. The infrared heaters are integrated into curved corners with a metal surface. The cabin frame and moulding are mahogany. The Finninfra infrared cabin of wood board and metal is supplied with the control IRC.
Infrared heaters: IR400 LUX 400 + 35W - 4 pcs.


Finninfra of panel elements

Finninfra cabin of woodboard and metal

The new infrared cabin in our range, which is made of panel elements. The exterior walls of the cabin are made of light aspen wood combined with heat treated abachi. The interior walls of the cabin are made of spruce. The seat is made of abachi wood combined with heat treated aspen. The cabin is available in three different sizes including an IRC36 control unit and 5 no of infrared heaters.

The infrared rays in an infrared cabin warm your body where needed. An infrared bath differs from the sauna in that aspect that the body is warmed up by means of the infrared wawes istead of by the surrounding air as in the sauna. Please note that you must consult your doctor about any health-related limitation to using infrared cabin. The infrared cabin is assembled from a few light elements in a couple of hours. The placing of an infrared cabin is very easy, because it needs no immediate water source.


 Infrared cabin, technical details
Supply voltage 230 V
Maximum power consumption 450W + 35W (for lamp)
Wavelength area of the radiator 4000 - 4500nm
Casing material of the radiator Stainless steel
 

Placing nearby a shower is recommended. The cabin requires electricity, of course. The preparation time is short, the infrared cabin is ready to be used after appr. 10 minutes after it has been put on.

Control IRC

(placed inside the cabin)


The infra wave length of 4000 – 4500 nm is ideal for a safe stay in a Lagerholm Finninfra cabin. With this wave length there are no risks involved and there is no cause for deeptissue-injury. The glow on an infrared element is visible when in action, which prevents an unintentional contact with the hot element. An additional light is not necessary as the infrared elements give enough light for the cabin. The Finninfra cabin works on a plug-in basis, which makes it very easy to enjoy.



Additional accessories


Loudspeakers, 2pcs

  • waterproof, resistant up to 120C
  • 80 W
  • colour: white
  • measurement: ø 16 cm

The right for technical changes reserved.